Low Fluorescence Western膜(PVDF) (ab133411)

概述

  • 产品名称
    Low Fluorescence Western膜(PVDF)
    参阅全部 Western blot membrane 试剂
  • 经测试应用
    适用于: WBmore details
  • 常规说明

    Pre-cut membranes (10 sheets, 7 x 9 cm), compatible with gels 10 x 10 cm and smaller. Note: PVDF membranes must be activated prior to use. Membrane activation protocol: 1. Pre-wet the membrane in methanol for a few moments until the membrane is completely wet. 2. Transfer the wet membrane from methanol to purified water and incubate on a rocker or shaker for at least 5 minutes. Make sure that the membrane is fully immersed in water and does not float on the water’s surface. 3. Transfer the membrane from water to transfer buffer, and incubate for 5 minutes.

性能

应用

Our Abpromise guarantee covers the use of ab133411 in the following tested applications.

The application notes include recommended starting dilutions; optimal dilutions/concentrations should be determined by the end user.

应用 Ab评论 说明
WB Use at an assay dependent concentration.

文献

ab133411 has not yet been referenced specifically in any publications.

客户评价及客户问答

We tried other popular PVDF membranes and just didn't get the sort of clarity we wanted until we started using the Optiblot reagent kits. The PVDF is recommended for use with the Optiblot kits and we have be able to obtain excellent transfer of protein from 17-well and 12-well Optiblot gels onto the membranes as well subsequent detection of a weakly expressed membrane protein.

The image is taken straight after blotting for 2 and a half hour in the Optiblot reagents, followed by Ponceau S staining for 1 minute, with ladder in blue and 17-lanes of protein (70ug per lane). The developed images is for detection of Beta-Actin.
The membrane itself is quite robust to stripping and not prone to tearing.
Overall, compared to other PVDF membranes, when combined with the Optblot reagents, we have seen a successful series of blots and detection of proteins.
Username

Dr. Raj Badhan

Verified customer

提交于 Jan 23 2014

I just noticed that I had forgotten to add the Western Blot guide that I mentioned in the last email. I have attached the guide to this email.

Please do not hesitate to contact us if you need any more advice or information.

Fre...

Read More

Thank you for contacting us.

Generally when transferring a very small protein, it is best to use a semi-dry transfer procedure. These usually run at 100V for 40-60 minutes. I would recommend transfer times at the lower end to this range. I...

Read More

Thank you for contacting us.

I have been in contact with the lab regarding ab133411. The pore size of the PVDF membrane is 0.45um

I hope this information is helpful to you. Please do not hesitate to contact us if you need any ...

Read More

Please note: All products are "FOR RESEARCH USE ONLY AND ARE NOT INTENDED FOR DIAGNOSTIC OR THERAPEUTIC USE"

注册